Qtech-data-systems Tait TM8000 Radio Manuel d'utilisateur télécharger pdf (Page 23)

Basic operation 23

Checking that a channel is clear

You or your user group may be segregated from other user

groups by special signalling. If an incoming call carries the

special signalling tones specific to you or your user group,

your radio’s signalling mute opens and you can hear the call.

These tones may not be audible.

The monitor function may allow you to override any special

signalling on a channel, so that you can check that the

channel is clear before you make a call.

Note: Your radio may be programmed to activate monitor

whenever the microphone is off the microphone clip.

To activate monitor, you may be able to either:

■ remove the microphone from the microphone clip, or

■ use a programmed function key.

Activating monitor by using a function key

To activate monitor and hear any traffic on the channel:

1 Press the function key programmed for monitor.

While monitor is on, the green LED flashes slowly.

2 Press the monitor function key again to turn monitor off.

When monitor turns off, the green LED stops flashing.

Note: Your radio may be programmed so that monitor turns

off automatically after a short time.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Pas de commentaire

Qtech-data-systems Tait TM8000 Radio Manuel d'utilisateur Page 23